Wing Mirror welcome light replacement

[Guest Sanjay]

meka wrote:

Hi Bros, has anyone changed the small w5w bulb under the wing mirrors.

Any bros able to enlighten on steps to access to the bulb, interesting and challenging to DIY the bulb replacement

Regards

i would pay the $10 to get the bulb changed.... but wish you luck on your diy

[Guest blackmercs]

Sanjay wrote:

i would pay the $10 to get the bulb changed.... but wish you luck on your diy

Lolz for the LED bulb cost is like $20++.

[Guest meka]

blackmercs wrote:

Meka bro!!

There is hope!!! Damage will cost u an arm & a leg!!

Hmm.. Still trying hard to figure out how to access to here..( the pictures above with the mirror taken apart)

Cost of Led is not an issue, it is the satisfaction u get after the DIY.

[Guest blackmercs]

meka wrote:

Hmm.. Still trying hard to figure out how to access to here..( the pictures above with the mirror taken apart)

Cost of Led is not an issue, it is the satisfaction u get after the DIY.

U got to remove the side mirror then remove couple of screws & mirror mounting before u can reach the LED. This job is done by a local workshop.

[Guest meka]

blackmercs wrote:

Meka bro!!

There is hope!!! Damage will cost u an arm & a leg!!

Bro Blackmercs, can show us more pictures of the mirrors that r taken apart so that it is easier to visualise where is the mirror piece and where r the securing clips that click and the location of groove that the clips usually holds. With that I will be able to try to pry open.. Without breaking any other parts will share the steps if successful.

[Guest blackmercs]

meka wrote:

Bro Blackmercs, can show us more pictures of the mirrors that r taken apart so that it is easier to visualise where is the mirror piece and where r the securing clips that click and the location of groove that the clips usually holds. With that I will be able to try to pry open.. Without breaking any other parts will share the steps if successful.

U wont break anything once u manage to pry open the mirror. Only then u are able to visualise the parts & pcs. Next, unbolt couple of screws to remove the mirror bracket. Too bad i didnt manage to figure out how they remove the LED holder.