Qn : How to remove rubber scratches?

[Slowpoke]

Dear all,

 

Sent back my car to C & C to redo the hyper optik film days ago as it was badly done - full of dust spots. After that, I found out that there are visible scratches on the rubber lining on the door (inner part as shown in the pic). Suspected these scratches were caused by the tool used to "push" the film in place. 

Does any bros / sisters know how to remove these scratches? Many thanks.

 

 

[zjared]

Get see&SEE to see and rectify.

[Slowpoke]

Get see&SEE to see and rectify.

They asked me to go to Toh Guan and look for the huper optik guy. I staying in the east.

[Ody_2004]

U deal direct with cnc? If so they shld rectify

[pattanct]

They asked me to go to Toh Guan and look for the huper optik guy. I staying in the east.

so you only move around in east? must make your horse run more....

[Slowpoke]

U deal direct with cnc? If so they shld rectify

they say its the fault of the hyper optik guys

[Slowpoke]

so you only move around in east? must make your horse run more....

i move ard. but this one doesnt have the incentive to do so. they damaged my car and i still have to drive all the way to west. sounds duh.

[Paladin]

Bro, dont know if it is possible to remove the scratches. Happened to my old jap car before and the workshop replaced the entire rubber part. I dont know the odds but hope that huper optik is willing to do that for you.

[Slowpoke]

Bro, dont know if it is possible to remove the scratches. Happened to my old jap car before and the workshop replaced the entire rubber part. I dont know the odds but hope that huper optik is willing to do that for you.

i dont think they will replace. I think they will just try their best to remove the  scratches. Thanks bro!

[MercZai ♫ Loüis ッ]

i dont think they will replace. I think they will just try their best to remove the  scratches. Thanks bro!

 

GO TO CNC AND BANG TABLE ! IS THEIR FAULT NOT YOURS, YOU DO NOT HAVE TO TROUBLE YOURSELF BY TRAVELLING. I WENT BACK TO DEMAND FOR NEW FILM WHEN BUBBLES APPEAR AFTER 3 DAYS.

 

 

oops. sorry bout the caps  but u should be firm like "cap locks" when you are at CNC

 

btw, mind pming me your Sales Executive name?

[Slowpoke]

GO TO CNC AND BANG TABLE ! IS THEIR FAULT NOT YOURS, YOU DO NOT HAVE TO TROUBLE YOURSELF BY TRAVELLING. I WENT BACK TO DEMAND FOR NEW FILM WHEN BUBBLES APPEAR AFTER 3 DAYS.

 

 

oops. sorry bout the caps  but u should be firm like "cap locks" when you are at CNC

 

btw, mind pming me your Sales Executive name?

i told my SE, im buying an experience not just a car. yes will be going back to c n c later.